When it was on 7500 dpi the scales in the dwf Design review were still very unaccurate.

This is not an official translation and may contain errors and inaccurate translations.

Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.

With the introduction of Design Review I had been scratching my head about the distance command.

Why wasnt it giving me an accurate dimension every time And why was I getting a different distance every time I made a DWF of the same drawing file So I took my questions to Autodesk and they actually scratched their heads for a couple of days about it.

If you open the DWF6 eplot.pc3 file, go to the Device and Document Settings tab.

Scroll down and click on the Custom Properties section and then double click on the Custom Properties Dialog box button to access the information.

In the upper right hand corner of the dialog box youll see Custom vector resolution: and its by default set to 400dpi.

I kind of did an aye-aye-aye like one of the Three-Stooges, but I did it anyway.

As a result, my DWFs are now scale-able and good to use by anybody for anything.

So I bumped it down a little to 10000dpi and still got good results.

Just a tip I thought I might try sharing with you all.

Enjoy.

If you would like to see a DPI chart of values and resulting precision, you can look here: If you would like info on the steps to changing this value: wrote in message news:5549362discussion.autodesk.com.

Heres a diddly-eye-joe-to-damned-if-I-know for ya.

I have to mention its a 30 meter long plot).

Dwf6 Eplot.Pc3